CWS Impact Garage Doors Nationwide

CWS Impact Garage Doors: The Orlando Owner’s Guide

We stock and install CWS-compatible impact garage doors throughout Orlando, with most complete door replacements running $3,400 to $7,800 installed, depending on size, wind-load rating, and whether you’re replacing the track and opener too. If you’re dealing with a failed panel, broken spring, or a door that won’t seal after a storm, we carry the parts on our trucks and can typically match your CWS model same-week. You usually discover the problem in one of two ways: you hear a bang in the middle of a summer thunderstorm, or you notice daylight sneaking under a corner that used to sit flush.

Call (850) 679-8554

Which CWS Models This Applies To

CWS impact garage doors come through Orlando in a few distinct series lines, and the compatibility question trips people up more than any other. The CWS 700 Series and 900 Series are the two you’ll most commonly see on Central Florida homes, and they are not interchangeable at the hardware level. Track pitch, hinge mounting points, and panel thickness all differ between them.

The fastest way to identify what you have is to look for the manufacturer label on the inside edge of the door, usually on the top or bottom panel. It’ll list the series number, wind-load rating, and a production date. If the label is gone, measure the panel thickness: 700 Series panels run 1-3/8 inches thick, while 900 Series panels run 2 inches. That single measurement tells us almost everything we need to know before we show up.

On OEM versus aftermarket parts: for anything structural like struts, hinges, or the bottom retainer that holds the weatherseal, we stock CWS-specific hardware. It costs more than generic equivalents but it’s engineered for the specific wind-load math on these doors. For rollers, cables, and springs, quality aftermarket equivalents are fine and we’ll tell you when they are. We’re an independent service provider, not affiliated with CWS, which means we can be honest about when the OEM tax is worth paying and when it isn’t.

Signs Your CWS Impact Garage Door Is Failing

• Door sags or hangs unevenly when it’s halfway up. That’s usually a spring that’s lost tension, or a cable starting to fray. On impact-rated doors like CWS, the extra panel weight makes spring wear show up earlier than it does on a standard door.
• You hear grinding or popping during operation. Older rollers wear flat spots after years of cycling in Florida humidity, and the pop is the roller binding in the track. Ignoring it turns a $12 roller into a warped track.
• Water pools at the bottom corners after a rain. The bottom weatherseal on CWS doors compresses over time, especially on the west-facing exposures around Dr. Phillips and Windermere that bake in the afternoon sun. The seal hardens, shrinks, and stops making contact.
• Visible rust on struts or hinge plates. Impact doors carry heavier reinforcement hardware, and coastal-adjacent air plus garage humidity accelerates corrosion. Surface rust is cosmetic. Flaking rust on a strut is a structural concern, because that strut is part of what keeps the door from folding under wind pressure.
• The door shudders or flexes when wind hits it. If you can see the door skin move during a strong gust, the panel-to-strut connection has loosened. A properly reinforced CWS door shouldn’t visibly flex, period.

Replacement Cost & What’s Included

Here’s what we tell Orlando homeowners, and what we put in writing before anything gets ordered.

• Complete door replacement: $3,400 to $7,800 installed. The spread depends on door width and height, wind-load rating, insulation level, window inserts, and whether we’re reusing your existing track and opener or replacing them.
• Single panel replacement: $425 to $950 per panel, installed. Panel replacement is usually the right call when damage is isolated to one section, and your door is less than 8 to 10 years old. Older doors often need new hinges and rollers at the same time because the existing hardware is already near end of life.
• Spring replacement (pair): $185 to $340 installed. We always replace both springs, even when only one has snapped. They wear on the same cycle count, and replacing one is how you get a door that jerks unevenly within six months.
• Weatherseal replacement: $85 to $150 installed. This is the cheapest repair on the list and the one that prevents the most water damage.

Every price we hand you is the price on the invoice. No change orders, no “we found it was worse than we thought” calls. We cover our workmanship for 365 days, parts and labor, in writing. If a repair fails within that year, the second visit is free.

DIY or Call Us?

Be honest with yourself on this one. If your issue is a worn weatherseal, a squeaky roller you can see from the floor, or a hinge that’s visibly loosened, a handy homeowner can handle those. Turn off the opener, lock the door in place, and go slow.

But here’s the line we won’t cross: if your CWS door has a snapped torsion spring, do not touch it. These springs are under enough tension to break bone or worse. It’s the most common injury we see in garage door work, and it’s the one repair where saving $200 genuinely isn’t worth the risk. Same goes for cables. If a cable has come off the drum, call us. Call (850) 679-8554 and we’ll get a tech out with the right tools and the right tension specs. “If I wouldn’t put it on my own house, I’m not putting it on yours.”

FAQs

Contact

If your CWS impact garage door is failing, don’t wait until the next storm finds the weak spot. Call (850) 679-8554 for a free estimate. Sean Mackey and the Juniper Windows Orlando crew have been swapping out tired garage doors across Orlando, from College Park to Lake Nona, for years. We’ll tell you what’s wrong, what it costs, and what we’d do if it were our house.

Written by Sean Mackey, Owner, Juniper Windows Orlando at Juniper Windows Orlando, serving Orlando and nearby areas.